CAD Cart (0)
  • Cart is empty
  • Low Pressure


    Elbows, Tees, Crosses, Couplings, and Bulkheads to 15000 psi (1034 bar).
    Autoclave's low pressure compression fitting line for use with 1/8" to 1/2" tubing rated to 15000 psi (1034 bar).

  • Low Pressure


    Elbows, Tees, Crosses, and Couplings to 15000 psi (1034 bar).
    Autoclave's Mini Series compression fitting line for use with 1/16" to 1/8" tubing rated to 15000 psi (1034 bar).

  • Line-Filters_Low


    O-ring and Ball Check Valves, and Excess Flow Valves to 15000 psi (1034 bar).
    Check valves to provide unidirectional flow with back flow shut-off for liquids of gases. Excess flow valves available in o-ring and ball design for surge protection.

  • Line-Filters_Low


    Dual-Disc and Cup Filters to 15000 psi (1034 bar).
    Dual-Disc filters used to trap larger particles in first filter to prevent clogging of smaller filter. Cup filters are used for high flow rates and provide maximum filter area.

  • Tubing_Low

    Autoclave Engineers offers a complete selection of annealed, seamless stainless steel tubing designed to match the performance standards of Autoclave low pressure valves and fittings. Autoclave low pressure tubing is furnished in random lengths between 20 feet (6 meters) and 27 feet (8.2 meters). The average is 24 feet (7.3 meters). The tubing is available in five sizes and a variety of materials. In order to ensure proper sleeve “bite” into tubing, Autoclave Engineers specifies and controls the strength levels of both the tube and sleeve materials.

    Inspection and Testing
    Autoclave Engineers low pressure tubing is inspected for compliance with specified defect restrictions as well as carburization or intergranular carbide precipitation. The tubing outside diameter and wall thickness is controlled within close tolerance to assure proper fit. Sample pieces of tube (for each lot) are tested to confirm mechanical properties for proper compression sleeve “bite” and pressure capability. Furthermore, the sample tubes are pressure tested as a final check.

    Special Materials
    In addition to the type 316 and 304 stainless steel tubing listed in this section, Autoclave has a limited stock of hard-to-obtain shorter lengths of the following tubing materials:
    Monel 400*, Inconel 600*, Titanium Grade 2*, Nickel 200*, Hastelloy C276* - (* Trademark names)

    Please consult factory for stock available.

    All dimensions for reference only and subject to change.
    For prompt service, Autoclave stocks select products. Consult your local representative.
    All general terms and conditions of sale, including limitations of our liability, apply to all products and services sold.