Corporate Home
Search Catalog
      GO   
 All Categories    Pipe O-Ring Check Valves
View Cart View RFQs  | Shipping 
 | Tax 
 | Terms
 Shopping Cart 0 Items
 Request for Quote 0 Items
All Categories > High Pressure Fittings and Tubing > P Series Pipe Fittings > Pipe Check Valves > Pipe O-Ring Check Valves > Item # CPO12  
Download PDF Download PDF     Printable Page     Email Email This Page     Save To Favorites Save To Favorites
Add To Cart Request Quote

Item # CPO12, Pipe O-Ring Check Valves



Provides unidirectional flow and tight shut-off for liquids and gas with high reliability. When differential drops below cracking pressure*, valve shuts off. (Not for use as relief valve.)

Materials: 316 Stainless Steel: body, cover, poppet, cover gland. 300 Series Stainless Steel: spring Standard O-ring: Viton, for operation to 400° F (204°C). Buna-N or Teflon available for 250°F (121°C) or 400°F (204°C) respectively; specify when ordering.

*Cracking Pressure: 20 psi (1.38 bar) ±30%. Springs for higher cracking pressures (up to 100 psi (6.89 bar)) available on special order for O-ring style check valves only.

Minimum operating temperature for standard o-ring check valves 0°F (-17.8°C).
Check Flow - water, GPM
For flow rates using alternate fluids, consult Autoclave Engineers.

CAUTION: While testing has shown O-Rings to provide satisfactory service life, both cyclic and shelf life may vary widely with differing service conditions, properties of reactants, pressure and temperature cycling and age of the O-ring. FREQUENT INSPECTIONS SHOULD BE MADE to detect any deterioration, and O-rings replaced as required.

NOTE: NPT (Pipe) Connections:
- NPT threads must be sealed using a high quality PTFE tape and/or paste product. Refer to thread sealant manufacturer's instructions on how to apply thread sealant.
- Sealing performance may vary based on many factors such as pressure, temperature, media, thread quality, thread material, proper thread engagement and proper use of thread sealant.
- Customer should limit the number of times an NPT fitting is assembled and disassembled because thread deformation during assembly will result in deteriorating seal quality over time. When using only PTFE tape, consider using thread lubrication to prevent galling of mating parts.





 Specifications   

Connection Type

3/4" NPT

Pressure Rating

10.000 psi
689.46
bar

Minimum Opening

0.52 in
13.21
mm

A - Length

6.29 in
159.77
mm

B - Length

4.75 in
120.65
mm

C - Typical Hex

1.75 in
44.45
mm

D - Typical Hex

1.38 in
35.05
mm

Rated Cv

4.70



 DOWNLOADS 

P-Series-Pipe-fittings-brochure
(PDF, 2354KB)


Add To Cart Request Quote

2012©All Rights Reserved • Parker Autoclave Engineers • Erie, PA USA